Difference between revisions of "Gas Mixer"

Revision as of 12:26, 8 May 2019

The adjusting screws are illustrated in this diagram Media:Gas Carb.jpg‎ . Correct mixture is achieved by winding the adjusting screw out until the engine runs rough and then back in again until it runs smoothly. This must be done at tick-over using the small screw above the throttle adjustment screw and on 'Wide Open Throttle' using the large hexagon headed screw.

Revision as of 12:23, 8 May 2019 (edit) Chair (talk \| contribs) ← Older edit		Revision as of 12:26, 8 May 2019 (edit) (undo) Chair (talk \| contribs) Newer edit →
Line 1:		Line 1:
	*Tuning the Impco C1-30 gas mixer		*Tuning the Impco C1-30 gas mixer

−	* The adjusting screws are illustrated in this diagram [[Media:~~Gas_Carb~~.jpg‎]] . Correct mixture is achieved by winding the adjusting screw out until the engine runs rough and then back in again until it runs smoothly. This must be done at tick-over using the small screw above the throttle adjustment screw and on 'Wide Open Throttle' using the large hexagon headed screw.	+	* The adjusting screws are illustrated in this diagram [[Media:Gas Carb.jpg‎]] . Correct mixture is achieved by winding the adjusting screw out until the engine runs rough and then back in again until it runs smoothly. This must be done at tick-over using the small screw above the throttle adjustment screw and on 'Wide Open Throttle' using the large hexagon headed screw.