Difference between revisions of "Gas Mixer"
From SSS Wiki
Jump to navigationJump to search (Created page with "*Tuning the Impco C1-30 gas mixer * The adjusting screws are illustrated in this diagram . Correct mixture is achieved by winding the adjusting screw out until the engine run...") |
|||
| Line 1: | Line 1: | ||
*Tuning the Impco C1-30 gas mixer | *Tuning the Impco C1-30 gas mixer | ||
| − | * The adjusting screws are illustrated in this diagram . Correct mixture is achieved by winding the adjusting screw out until the engine runs rough and then back in again until it runs smoothly. This must be done at tick-over using the small screw above the throttle adjustment screw and on 'Wide Open Throttle' using the large hexagon headed screw. | + | * The adjusting screws are illustrated in this diagram [[Media:Gas_Carb.jpg]] . Correct mixture is achieved by winding the adjusting screw out until the engine runs rough and then back in again until it runs smoothly. This must be done at tick-over using the small screw above the throttle adjustment screw and on 'Wide Open Throttle' using the large hexagon headed screw. |
Revision as of 12:23, 8 May 2019
- Tuning the Impco C1-30 gas mixer
- The adjusting screws are illustrated in this diagram Media:Gas_Carb.jpg . Correct mixture is achieved by winding the adjusting screw out until the engine runs rough and then back in again until it runs smoothly. This must be done at tick-over using the small screw above the throttle adjustment screw and on 'Wide Open Throttle' using the large hexagon headed screw.
